Wireless, up to 30m range, receiver
with built-in battery recharger.
The Maximum Remote Control Extender
is a great new product that works with any infrared remote control for any TV,
VCR, Satellite Receiver, or other infrared remote controlled device. It allows
you to control any IR device through walls, ceilings, and floors using RF what
you would normally not be able to control. It is very easy to setup and use.
only €59.85
AV REMOTE
Remote Control Extender€49.59
Specifications:
Operating Voltage
230 or 240 VAC, 60Hz/DC 12V,
150mA
Power Consumption (pair)
4 Watts Max.
Transmission Frequency
433.9 MHz +/- 250 KHz
Power Gain
10dBM
Effective operating range
about 35M (clear line of sight)
Infrared Receiver Section: Tuning Frequency
38 KHz
Infrared Emitter Section:
Carrier Frequency (R/C)
38 KHz
WIRED REMOTE SENDER
General Applications:
Remote control your TV Set, VCR, STB, PVR and other audio/video and
Hi-Fi equipment from another room via existing coax cables
Uses existing wall sockets and coax installation to transmit IR signal
Very easy installation. Just plug into wall socket in both rooms
(both wall sockets must be interconnected, and support 11 MHz, to work)
Receiver and re-transmitter IR-eyes with 2 meter cable each
Unit has very low insertion loss from wall outlet.
AV LINK
€95
€120
Transmits sounds and pictures from any of your AV
devices to a second TV wireless...
Two SCART input connectors on the transmitter allow you to connect two
AV devices
AV source switch allows you to select one of the two AV devices whose
program you can then be viewed on your main TV, second TV or both
Converting back and forth between infrared signals to radio frequency
signals, the Dual Audio Video Sender makes use of your exiting remote
controls form other rooms in the house
The complete kit is easily and quickly installed
PAL and NTSC compatible
Uncomplicated and stylish design suits any home
2.4 GHz signals can penetrate walls, floors and ceilings, and has a
range of approximately 300 feet in open areas
Specification
A/V Transmit Frequency: 2.4 GHz
Remote Control Frequency: 433.92 MHz
A/V Signal Range: 100 meters (300 feet) clear line of sight
Remote Control Signal Range: 70 meters (200 feet) clear line of sight
Antennas: Omni-directional antenna
Channel: 3 selectable channels
A/V mod/Demod. Method: FM
Audio: Stereo audio input and output
Video: Composite video input and output
Dimensions: 22 (W) x 6.2 (H) x 17.5 (D) cm (8.7 x 2.4 x 6.9 inches)
each for transmitter/receiver
click to go to Micronet official page and find what you
want
D-LINK
DVI
HDMI
HDMI TO
DVI
SCART TO SCART GOLD €25
SCART TO RCA €30
FIBER OPTIC €30
null modem cable
£3,90
PLUGS
F Connector
RG6
Black OR WHITE cable
FROM
£0,3/m
USB,USB2
CAT5e CABLES
These Cat5
Network Cables are perfect for use with 10/100/1000Mbps Ethernet networks.
Complete with RJ45 male to male connectors these top quality cables are
available in a wide range of lengths USE WITH DREAM!!
also available cat6
Humax Humax Remote
Fox, 5300, 5400 compatible
Replacement remote for HUMAX
Fox, 5100, 5300 and 5400 receivers.
Fully Wired 21 Pin 1.5M
High quality Scart to Scart, SCART TO RCA GOLD PLATED leads
FROM €5
4 Core
Motorized satellite cable
Emitor AB DigiSat
Pro:
Για ταυτόχρονη εγκατάσταση δύο πιάτων και λειτουργία
diseq 2 in 1 out!!!
Το DigiSat
Pro είναι ένα όργανο τύπου sat finder της σουηδικής Emitor AB, το οποίο
είναι σε θέση να αποσπάσει ταυτόχρονες μετρήσεις signal strength από δύο
διαφορετικά LNB, αφού είναι εφοδιασμένο με τις αντίστοιχες εισόδους. Οι
μετρήσεις απεικονίζονται τόσο γραφικά, όσο και σε αριθμητική τιμή, ενώ η
ηχητική ένδειξη, επιτρέπει την εκτίμηση της έντασης του σήματος με
ακουστικό τρόπο.
Η είσοδος IF
επιτρέπει την σύνδεση της συσκευής με δορυφορικό δέκτη, ώστε ο χρήστης να
αποσπάσει οπτικές ενδείξεις για το ρεύμα, την τάση και την παρουσία ή
απουσία του τόνου 22kHz, που αποστέλλει ο δέκτης μέσω του ομοαξονικού
καλωδίου. Παράλληλα, το όργανο χρησιμοποιεί τα σήματα ελέγχου του
δορυφορικού δέκτη 13/18V, 22kHz, DiSEqC 1.0 και 1.1 και υποστηρίζει σήματα
μετακίνησης του κατόπτρου, όπως DiSEqC 1.2 και Nokia Sat Scan. Παράλληλα,
από τον ίδιο ακροδέκτη είναι εφικτή η τροφοδοσία του οργάνου, ενώ
εναλλακτικά μπορεί να επιτευχθεί από αντάπτορα 12-18V. Το εύρος ζώνης του
sat finder είναι από 900-2150MHz, ενώ τα μενού του απεικονίζονται στην LCD
οθόνη του. Το DigiSat Pro ζυγίζει μόλις 0,1kg !!!
The first of its kind
worldwide in the area of measuring technology for SAT systems. The handy
DIGISAT Pro makes it possible to measure two LNB`s / antennas at the same
time. The ideal instrument for the exact lining-up of multi-feed systems.
With the integrated DiSEqC sender (up to V. 1.2), you can not only easily
align DiSEqC-controlled spinner systems, but also produce all DiSEqC and
22 kHz commands relevant to a typical system for checking purposes and
show them on the LC display. Moreover, the DIGISAT Pro can be usedas a
volt/amperemeter (0-30V, 0-900mA), as a dual DiSEqC switch and as a
22-kHz/DiSEqC generator for testing multi-switches, DiSEqC-LNB`s and
DiSEqC antenna rotors. The DIGISAT Pro is immediately ready for use after
installing in line with the coaxial cable. An external power supply (12 -
20VDC) can also be used to operate the DIGISAT Pro.
Technical data: Frequency range 2 x 950-2200 MHz, input level 20-100 dB
µV, insertion loss 5dB, signal display LCD/acoustic, DiSEqC 1.0 - 1.1 -
1.2, MiniDiSEqC (Tone Burst), 22 kHz function, protected against
short-circuiting, weight 100 g.
Send mail to sales@satcy.comwith
questions or comments about this web site.
Last modified:
Monday, 25. August 2008!!!
)
Emitor AB DigiSat
Pro: