Supplied
with two jumper selectable (3.5 and 6.0Mhz) The unit is powered from
the serial port or a 7,5V Power Supply. Can be used as reader for DreamBox
and pc
Can also be used for many other applications and smartcards that follow the
ISO Protocol like GSM SIM
6,8 cm x 6,6 cm x 1,9 cm
€50
SPECIAL OFFER: PROGRAMMER, POWER SUPPLY, RS232 ONLY:
£35,95
SC8in1 - Module Full Assembled for 8 smartcard - units for
DREAMBOX, PC or external
housing.
This ready made, full assembled SC8in1 - module is able
to control up to 8 smartcard - units. It is recommended for the control of
smartcard - units, which have been built into a external housing.
Using a RS232-TTL converter, it can be built into devices
which do posses a RS232 port.
€
RS232 TTL Converter
The RS232 TTL converter, converts the RS232 signals
TX, RX, RTS, CTS and DTR to TTL level and enables the connection of
SC8in1 to the serial port of a PCs, Dreambox, DVB Receiver, etc.
The connection to the serial port is established
through a D-SUB connector. In addition also a 10pole pin row is present,
in case a internal connection to a PC is desired. The connection to the
TTL connector is established through a 20 pole connector.
€
SC8in1 4 Smartcard Connector Kit
The smartcard connector kit consists of four ISO7816
smartcard units, four PCBs, four pcs. 10 pole pin rows, 8 connectors and
1m flat cable. The connectors are compatible with the connectors of the
SC8in1 interface.
On the left and right side of the PCB pads are present,
which do provide the opportunity to connect the PCBs in any desired distance
and also displacement in steps of 2,54 mm - useful if installation in a
external housing is desired.
all 3 for : €260
Accessories
power supply for programmers
Regulated plug-in adapter
Linear regulated circuit is used to regulate its output voltage
TOUCH
HD
